Out-5 > Push TS

Configure a DME Stream : DME Output Streams : Out-5 > Push TS

Out-5 > Push TS

To configure a Push TS output:

Objective: This use case explains how to distribute available streams to unicast or multicast Transport Stream destinations. Note that although any stream available to the Multi- Protocol server can be distributed as a Transport Stream, if it is required for KLV metadata, the stream must remain in a Transport Stream container in all cases.

1. Enter the destination unicast or multicast address.

2. Enter the destination port to send the stream to.

3. Enter the name of the incoming stream you want to distribute to your destination.

4. Enable the stream and click Apply.

5. The status will indicate either “Sending” or “Waiting for Stream” if the specified input stream cannot be found.

6. You can also verify the detailed status of your outbound transport stream on the Monitor> Multi Protocol Connections page.